top of page
Compressor Cylinder Repair
Cylinder with large area of pittings
  •  Design and Manufacturer Compressor Cylinder Liners & Sleeve

  • Manufacture and refurbish power cylinders and power liners

  • Compressor cylinder boring oversize to oversize piston

  • Cylinder Re-lined

  • if your cylinders have large pitting's or may be too loose ( do not throw them away)

  • We inspect, measure and record dimensions of all cylinder bores, before and after remanufacture to insure compliance with applicable piston tolerances and specifications. 

  • Cylinder bores cross hatch to retain oil, while allowing the piston rings to slide over the mostly smooth surface and seal against the pressure of combustion gases.  while also resulting in lower oil consumption by the engine.

  • We will install a new sleeve, then  bore and hone to match your piston

  • when inquiring we ask you give us the following details to ensure we give you the best possible answers

    • Cylinder bore size ( inches/metric)​

    • Cylinder Length 

    • Quantity of cylinders to be repaired

    • Piston availability

  • All Cylinder Sleeves are built in-house by Accurate Cylinder & Sleeve  Works ( ACAS works )

Cylinder with raw stock ready to be machined
bottom of page